Systems are provided with good quality pressure guages with isolator for safety. In addition, extra guage points also provided with minimess coupling to fecilitate maintenance
System is design for the operating logic with multiple flow and pressure controls as desired
System is design with adequate care to ascertain the right sizing and selection of component taking into account the application and duty cycle
Systems are designed with energy conservation with the help of high - low circuits, accumulators and variable delivery pumps
Systems are also designed for Closed Loop applications with Proportional valves for high accuracy and automation controls. Systems are also designed with Hydro - Static Drives
System is Designed using all standard makes such as Yuken
Pump Suction are provided with 149 micron mesh type strainers or filters as standard
Pressure lines filters of 3, 5, 10 microns with absolute beta reating better then 200 are provided if required
Magnatic Tank cleaners Suspended inside the tank are also provided if required
Tubes are also burnt at high temperatures to melt low mass metels particles and then Zinc Passivated
Continuous off-line Filtration system are also provided if desired
Return lines are provided with 10 or 25 micron suitably sized filters as standard
Firstly tanks are sized suitably to provide natural cooling to maintain oil temperature below 15° C above ambient
Tank submersed heat exchangers are also provided as a special case
If the natural cooling is not suffcient then additional water cooled or air cooled heat exchangers are provided in the systems,These are either water cooled shell and tube type / Plate type or air cooled Radiator type coolers
Continuous Off - line Cooling systems are also provided if desired
Tanks are Designed with sufficient thickness to ensure strength and rigidity and mimimum weld joints
All joints like top plate assembly to tank, pipe entries from top plate etc.are sealed using suitable elastomer
Tanks are fabricated from mild steel or Stainless Steel and also from Die Cast Aluminium
Tank Top Plate is Mild Steel, Stainless Steel or Aluminium of sufficent thickness to ensure rigid support to the whole assembly
Accessories provided such as Oil collection tray on the top in periphery, Drain Valve, Air breather, Oil level Gauge, Inspection Cover
Mild Steel Tanks go through a 7 tank cleaning process after which they are phosphated and powder coated
Tubes are suitably for oil velocity and pressure
All pipes are well supported using suitable clamps aesthetically laid out
Cold Drawn seamless tubes as per DIN2391 are used for piping
Ermetto bite type ferrule fittings are used for low pressures and weld-on-nipple or SAE flanges are used for high pressures
The unit is either mounted vertically with pump immersed inside the tank for positive suction and low noise level or horizontally for ease of replacement as per choice
Large pump-motor assemblies are also mounted at the side of the tank for positive suction
The units are coupled with bell housing and flexible drive couplings
Generally 15HP and above installations are Horizontal and on anti - vibration pads and a common plates